The 2011 Sonata has a tail light socket that is different from other years. The difference is that the ground wire is attached to the bottom of the socket instead of the side. This can cause problems when installing aftermarket lights because the ground wire may not make contact with the new light.
If you’re having trouble with your 2011 Sonata’s tail light socket, don’t despair! This is a relatively easy problem to fix.
First, check the fuse box under the hood to see if the fuse for the tail lights has blown.
If it has, replace it with a new one and see if that fixes the problem.
If the fuse isn’t the issue, then it’s likely that the socket itself is defective. You can try replacing it with a new one, or you can solder the wires directly to the bulb.
Either way, this is a relatively easy repair that shouldn’t take more than a few minutes.
2011 Hyundai Sonata Tail Light Socket Replacement
If you have a 2011 Hyundai Sonata, you may find that the tail light socket needs to be replaced. This is not a difficult task, but it is one that requires some patience and attention to detail. Here are the steps you’ll need to take to replace the tail light socket on your 2011 Hyundai Sonata:
1. Start by removing the two screws that hold the taillight assembly in place. These screws are located at the top of the taillight assembly.
2. Once the screws are removed, carefully pull the taillight assembly away from the car body.
Be careful not to damage any of the wiring as you do this.
3. Locate the tail light socket inside the taillight assembly. It will be held in place by a retaining clip.
4. Use a small flat-head screwdriver to release the retaining clip and remove the socket from its housing within the taillight assembly.
5 . Take your new tail light socket and insert it into its housing within the taillight assembly, making sure thatthe retaining clip secures it in place.
6 . Reattachthe taillight assemblyto your car body usingthe two screws you removedin step 1 . Make surethat everythingis securelyfastenedbefore movingon .
What are the 2011 Sonata Tail Light Socket
The 2011 Sonata features a unique and stylish tail light design. The socket for the tail light is located on the back of the car, just below the taillight itself. There are two screws that hold the socket in place, and these must be removed before the taillight can be replaced.
To remove the screws, simply use a Phillips head screwdriver. Once the screws are removed, gently pull out the old socket and insert the new one in its place. Be sure to line up the holes in the socket with those in the car so that it will fit snugly and securely.
Finally, replace the screws and tighten them until they are snug. That’s all there is to it! With this simple process, you can easily change out your Sonata’s tail lights whenever you need to.
Tail light socket replacement #1
Conclusion
If your 2011 Sonata has a burnt out tail light, you may be able to replace the socket without having to replace the entire light assembly. This blog post provides step-by-step instructions for removing the old socket and installing a new one. You’ll need a few tools, including a screwdriver and pliers, and it’s helpful to have someone else around to help hold the light assembly while you work.
With a little time and patience, you can save yourself some money by replacing just the socket.