2009 Kia Optima Tail Light

2009 Kia Optima Tail Light. The Optima’s tail light is a clear and bright LED that illuminates the entire rear of the vehicle. When braking, the light intensity increases to make sure drivers behind you are aware.

If you’re looking for a great deal on a used car, the 2009 Kia Optima is a great option. This sedan has plenty of features to offer, including power windows and locks, cruise control, and more. Plus, the tail light is a great safety feature that will help you be seen in low-light conditions.

2009 Kia Optima Tail Light Replacement

If your 2009 Kia Optima is in need of a new tail light, you’re in luck. Replacing the tail light on this vehicle is a relatively easy process that can be completed in just a few steps. Here’s what you’ll need to do:

1. Start by opening the trunk and removing the two screws that secure the taillight assembly in place. 2. Next, disconnect the wiring harness from the back of the assembly by pressing down on the release tab and pulling it away from the connector. 3. With the wiring disconnected, you should now be able to remove the entire taillight assembly from its housing in the trunk area.

4. Take your new tail light and connect it to the wiring harness, making sure that it is properly secured in place. 5.Finally, re-install the assembly into its housing and screw it into place until it is snug and secure.

Is the Tail Light And Brake Light the Same Light?

No, the brake light and tail light are not the same. The brake light is a red light that comes on when you apply the brakes. The tail light is a white or red light that illuminates the rear of your vehicle so that drivers behind you can see it at night or in low-visibility conditions.

Which Bulb on Tail Light is Brake Light?

There are typically two bulbs on a car’s tail light: one for the brake light and one for the taillight. The brake light is usually the brighter of the two bulbs. When you hit the brakes, the brake light comes on and illuminates your car’s rear so that drivers behind you know to stop.

How Do You Change a Taillight on a Kia?

If you have a Kia that needs a new taillight, don’t worry – changing it is easy! Here’s how to do it: 1. Start by opening the trunk of your Kia.

There will be a panel on the inside of the trunk lid that needs to be removed in order to access the taillights. Use a screwdriver or other tool to remove the panel and set it aside. 2. Once you have access to the taillights, locate the two screws that hold each light in place.

Remove these screws with a Phillips head screwdriver and pull out the old light assembly. 3. Take your new taillight assembly and connect the electrical connector (if applicable). Then insert the assembly into place and screw it in using the two screws you removed earlier.

4. Replace the trunk panel and close the trunk. You’re all done!

Are There Any Recalls on a 2009 Kia Optima?

Yes, there have been some recalls on the 2009 Kia Optima. In 2012, a recall was issued for a problem with the power steering system. Another recall was issued in 2013 for a problem with the front passenger airbag.

How to Remove and Replace a Brake Light Bulb and Assembly – 2005 Thru 2010 Kia Optima


The 2009 Kia Optima has a new look and feel that is sure to turn heads. The sleek lines and bold colors are attention grabbers, but the real story is under the hood. TheOptima comes standard with a 2.4-liter four-cylinder engine that produces 175 horsepower and 168 pound-feet of torque.

It’s mated to a five-speed manual transmission or an optional six-speed automatic. Fuel economy is an impressive 24/34 mpg city/highway with the manual and 23/32 with the automatic.

Leave a Comment

Your email address will not be published. Required fields are marked *